LOOKAH 07 MINI ENAIL

Description

LOOKAH 07 MINI ENAIL
Lookah Q7 Mini The latest E-nail dabber for 2022
The Lookah Q7 Mini is smaller, sleeker, and easier to use than the previous Lookah E-nails. It has a 950mAh battery offers around 80 to 100 uses on a single charge.
It uses the 710-thread quartz atomizer range for a better taste profile. Four different coil types exist so that you can select the best heat and flavor profile. Like its predecessor, the Q7
mini will fit most 14mm to 18mm pipes. A silicon sheath for the downstem allows for use with smaller joint lines, which can be removed when using the enail larger dab rigs.
Three voltage settings on the Q7 mini can be adjusted by double-clicking the power button.
mode 1, 3.2V, mode 2, 3.6V and mode 3, 4.0V. These settings adjust the temperature between 350 to 450 degrees Fahrenheit. These low vaping temperatures help preserve the
terpenes and flavonoids, allowing for a more flavorful experience.

How to Use the Q7 Mini Enail
Place the Q7 mini into the downstem of your water pipe.
Open the magnetic flip cap and place a small amount of wax into the center of the atomizer coil.
Close the flip cap
Press the power button 5 times within 2 seconds to turn on the Q7 Mini enail.
The device will enter a preheat mode, and the display will show a countdown from 9 to O as the preheat is active.
After the preheat has finished, the light will flash 2 times.
Press the power button 2 times to select the voltage mode.
Press and hold the power button for up to 10 seconds to heat the atomizer and vaporize the wax.
Inhale from the mouthpiece of the water pipe. You can adjust the airflow by covering the carb on the flip cap as required.
Be sure to wipe around the atomizer to remove any excess wax and turn the device off after you have finished using it.

How to Clean the Q7 Mini Enail
I. Open the magnetic carb lid
2. Remove the 710 thread atomizer by unscrewing it counterclockwise.
3. Remove the downstem by unscrewing it clockwise.
4. Use the brush and some isopropyl alcohol to clean the airway between the downstem and atomizer coil.
5. With some isopropyl and a Q-tip, swab the area around where the 710 coils would screw into the device.
6. Swab out the atomizer coil with a Q-tip and some isopropyl alcohol.
7. Clean around the carb cap and the body of the device with a Q-tip and some isopropyl alcohol.
8. When dry, reassemble the parts.

PRODUCT WARNING:-
Electronic Cigarettes are intended for use by existing smokers of the legal smoking age. Children should not use pregnant women who may become pregnant or anyone with pre-
existing medical conditions without first consulting their doctor. Electronic Cigarettes are not meant to cure, treat, or prevent any illness or disease. AK Wholesale products are intended
to be used as a tobacco alternative. These products are not marketed as smoking cessation, nor have they been tested. Keep out of reach from children & pets.
Coils will only work on a device capable of firing atomizers. You must ensure that your batteries can handle atomizers and coils. Please use at your own risk and always use proper
precautions and handling as these are very sensitive to charging characteristics and may explode or burn if not properly handled. Please note that there is an inherent risk with using
any coil or device and all rechargeable batteries. AK Wholesale Inc. is not responsible for any damage, injury, or defect caused by the improper use and mishandling of coils, devices,
Li-ion (Lithium-ion), Lipo (Lithium-ion Polymer), and any rechargeable batteries and chargers. Please use at your own risk, and before use, read the user’s manual carefully.
This product can expose you to nicotine known to the State of California to cause congenital disabilities or other reproductive harm. This product is not recommended for pregnant
women or people with cardiovascular issues. Always ensure that any E-juice is kept out of reach from children and pets. For more information, go to http://www.P65Warnings.ca.gov.